EmusBMS

33. What is the difference between User State of Charge and State of Charge?

With User State of Charge, you can set a range of usable real SOC. To set this range you need to go to Control Panel -> Configuration -> SOC/SOH -> User SOC config Parameters.

When the real value for the SoC is lower than ‘0% User SoC from Real SOC’ parameter, user SOC will be considered as 0%. Meanwhile if the real value for the SOC is higher than ‘100% User SoC from Real SOC’ value, then user SoC will be considered as 100%.

As Control Unit sends User SoC value, usable capacity will be limited, helping to extend battery life by setting the range in which the battery can be operated.

Get samples and test EMUS BMS!

+370 686 45554
On workdays 9 -18 (GMT +3)

Request and proposals
sales@emusbms.com

Service calls
Support@emusbms.com

Contact Form Demo