Please refer to documentation manuals and datasheets below for our products information. All related apps, software and firmware are listed as well.
G1 BMS system user manual which documents the whole BMS system components, connectivity, configuration, monitoring, troubleshooting and much more.Download Release Notes
2018-11-11 19:51:20Download Release Notes
Detailed description of G1 BMS CANopen Object DictionaryDownload
2018-12-10 10:31:23Download Release Notes
2018-12-10 10:34:09Download Release Notes
2019-05-28 09:26:19Download Release Notes
EMUS Centralized CAN Group Modules support
Added update and configuration support for EMUS Centralized CAN Group Modules.
Several additional error status reports added for update procedure.
Now when parameters which are unknown to Control Unit are requested, instead of endless polling of these parameters the cycle will break after one iteration of parameter set request.
During CAN Group Modules configuration procedure Control Panel sometimes could crash.
During Control Unit firmware update procedure Control Panel sometimes could crash.
2020-02-14 17:43:23Download Release Notes
Added fixed Powerfinn charger firmwareAdded SMA Sunny Island firmware
2019-03-19 18:15:34Download Release Notes
2018-11-11 20:55:19Download Release Notes
2018-11-11 20:52:43Download Release Notes
2018-11-11 20:49:04Download Release Notes
2018-11-11 20:46:08Download Release Notes
2018-11-11 15:05:58Download Release Notes
2019-06-18 16:55:43Download Release Notes
Value of 'Total Voltage' in Layout #4 was displayed incorrectly above 655 volts
Bootloader for EMUS BMS Mini devices.Download Release Notes
Firmware for EMUS BMS Mini devices.Download Release Notes
Added CANopen protocol support for Serial peripheral
Added Delta-Q charger support
Added CANopen client support
Added CiA 418 PDO support
Added pin function status report
Added power saving modes (storage - deep, automatic - light)
Added internal operational limits (current, temperature)
Added "Not detected battery" EMCY object
Added 'Storage mode' pin function
Improved battery detection mechanism
Added Current sensing configuration parameters
Fixed repetitive toggle between charging stages
Sometimes charging was impossible until any protection recovers
Sometimes protectiosn were not triggered properly
Fixed CANopen OD 0x6000
Sometimes protection was triggered twice resulting in registering duplicated protection
When all emergency error codes are cleared BMS did not switch from pre-operational to operational state.
CANopen OD 0x1001 incorrect update
Reset to factory defaults was not working correctly
Inverting GPO pin function did not work correctly
'Protection reset' pin function could be triggered once
Fixed initial notification of not detected batteries when system starts-up
When system starts contactor pre-charge is not activated before closing contactor
Notifications of End of Life announcement of EMUS products . For full history list of EoL notifications please press "Show all Versions" at the bottom.Download
Notifications of EMUS products price changes. For full history list of price update notifications press "Show all Versions" at the bottom.Download
Our company specialists are ready to provide technical assistance and consult in matters related with use of our products. In order to attain the best service quality, we kindly ask you to fill the contact form by clicking the button below.