News

53. Points to pay attention when CAN Devices are not discovered.

2022-05-01

• Check all LEDs are blinking. If one LED is not blinking, issue is on first not blinking Cell Module. • Check communication daisy chain is...

54. Which conditions can lead to the “Charging Error” stage?

by Emusbms

2022-05-01

Different conditions can lead to the “Charging Error” stage. These conditions are: • No cell communication. • Charging stage duration exceeded. • Detected number of cells does not...

55. Control Panel does not detect COM port where EMUS Control Unit is connected. What to do?

by Emusbms

2022-05-01

In this case, it is recommended to install FT232R USB UART DRIVER. Driver and step-by-step instructions can be found in the link below: https://emusbms.com/manuals-downloads...

56. How to unlock protected by password control unit?

by Emusbms

2022-05-01

To delete password from a password protected control unit, Master Clear process would be needed. Please, refer to page 126 of the G1 Control Unit...

57. How to reset configuration parameters to default values?

by Emusbms

2022-05-01

To reset your configuration parameters to default values, you just need to open your Control Panel, go to Configuration, then Management and finally press the...

58. How to capture logs from the EMUS Control Unit?

by Emusbms

2022-05-01

To capture logs from the EMUS Control Unit, you just need to select the option ‘Write Logs’ on the option window of the Control Panel....

52. Points to pay attention when incorrect number of cells error appears.

by Emusbms

2022-05-01

• Make sure that Number of Overall Cells is set correctly (Configuration -> General -> Battery pack -> Number of Overall Cells). • Make sure that...